Condute - Electrical Testing Equipment

Impact Tester

Approx Price: Rs 75,000 / Unit(s) 

The ASIAN Impact Tester Apparatus for conduit made on the rigid mild steel base on which jaws are provided for correct positioning of the specimen. There are two vertical pillars on which the falling height adjustment bracket is provided which can be set at different fall height of hammer. There is a steel intermediate pieces, connect to the triangular section guide rod on which the hammer of different weight is slide, when hammer fall on the steel intermediate piece. The steel intermediate piece always in the contact ct on the test specimen. The hammer is clamp by a spring-load lever. The lever is attached to the falling height adjusting mechanism. The hammer release when the spring-loaded lever presses. A 40 mm thick pad of sponge rubber also provided with the equipment.

Bending Test Apparatus

Approx Price: Rs 30,000 / Unit 

The ASIAN Bending Test Apparatus made on the rigid metallic base plate. There are three dimension groove discs of specified dimensions, the test specimen wrap on the center big size groove disc with the help of the two small size groove discs. The small size discs have the handle for apply the force on the specimen for bending. There is a sliding vee block for firmly holding the test specimen

The tester is finished is blue painting and bright chrome plating to give it a corrosion resistant finish.

Technical Data:

  • Conduit Size which are required for bending test: 16mm,20mm,25mm
  • Length of test speciement : 500mm

 

Collapse Test Apparatus

Approx Price: Rs 22,000 / Unit 

Using our years of experience and with the support of our diligent team of professionals, we are instrumental in providing quality assured Collapse Test Apparatus.

Samples of conduits made of insulating materials of length as specified in Table shall be bent at room temperature, the bending radius being as given in relevant conduit specifications. The samples are then fixed to a rigid support by means of four straps.

Table For Length Of Samples For Collapse Test

(Clause 9.5.1)

SIZE (MM)

Length (MM)

16

340

20

370

25

450

32

590

40

740

50

900

63

1130

If mechanical bending aids recommended by the manufacture are used for rigid conduits, the mechanical aids shall be removed. The support with the sample in position is kept for 24 hours in a heating cabinet at a temperature of 60 ± 2° C unless specified otherwise in the relevant conduit specification.

After the period, the sample still being secured to the support, the minimum internal diameter is checked as specified in the relevant conduit specifications.

Related Standard IS: 9537 (Part I) - 1980

Electrical Testing Equipment

Approx Price: Rs 75,000 / unit 

The Asian Electrical Testing Equipment consists of a gripping arrangement to hold the test specimen firmly with its axis vertical, and swivable Bunsen burner which can made vertical for setting the height of the flame, or inclined at 45º to the vertical to make the flame impinge on the surface of the test specimen at an angle of 45º. The height of the flame can be adjusted by controlling the rate of supply of LPG gas to the burner with the help of needle valve.

The apparatus is finished is blue painting and bright chrome plating to give it a corrosion resistant finish.

Related Standard

IS: 9537 (Part 1) – 1980: Specification for conduits for Electrical Installation Part 1:

General Requirements

IS: 9537 (Part 4) – 1980: Specification for conduits for Electrical Installation Part 4:

Pliable self recovering conduits of insulation material.

Looking for Condute - Electrical Testing Equipment ?
© Asian Test Equipments
 
Desktop Site Back to top